09-07-2022, 03:36 AM
(This post was last modified: 09-07-2022, 03:37 AM by mnrvovrfc.
Edit Reason: Fixed a typographical mistake
)
Note what is the time you run "qb64pe" program.
Compile your program with "-z" switch.
Then look into your "qbpe/internal/temp" directory.
Make sure there is anything in there which is very close to the time (ie. a few seconds later) you fired the "qb64pe" program.
Compile your program with "-z" switch.
Then look into your "qbpe/internal/temp" directory.
Make sure there is anything in there which is very close to the time (ie. a few seconds later) you fired the "qb64pe" program.